2-4
SPINNER Werkzeugmaschinenfabrik GmbH
SM-2-12/02
• If the machine is switched off completely for maintenance and repair work, then it
must be protected against an unexpected startup!
• Ensure that the operational and auxiliary materials, as well as old, exchanged
parts, are disposed of in a safe and environmentally sound manner!
• The operator must also make sure that no unauthorized persons work on the
machine!
• The operator is required to inspect the machine at least once per shift for
external damage and defects, and to inform the appropriate persons when a
change is discovered that affects the safety (and operation) of the machine!
• If the safety equipment needs to be removed when adding new equipment to the
machine or when carrying out maintenance or repair work, then the safety
equipment must be remounted and inspected immediately after the maintenance
and repair work is completed!
2.6 Personnel selection and qualifications
• Allow only trained or instructed personnel to work on the machine! Clearly define
which persons are responsible for the operation, equipping, maintenance and
repair of the machine!
• Make sure that the only persons that work on the machine are those assigned to
work on the machine!
• Personnel in training, receiving instructions or who are still in a general training
program are only to be allowed on the machine when under constant supervision
by experienced personnel!
• Work done on the electrical equipment of the machine may only be carried out
by an electrician or by trained personnel under the guidance and supervision of
an electrician in accordance with the regulations relating to electrical systems!
Work done on the hydraulic equipment of the machine may only be carried out
by personnel with special knowledge and experience in hydraulics! The
appropriate tools and equipment must be available!
2.7 General hazards on the machine
2.7.1 Mechanical hazards
• Danger of bodily injury in the form of bruises, cuts, bumps, stab wounds,
abrasions or any other injuries resulting from getting pulled into the machine,
etc.! These dangers are presented mainly by the moving machine parts, sharp-
edged workpieces/ sharp chips and filings, sharp tools, etc.! Do not reach into
moving machine parts!
2.8 Special types of hazards
2.8.1 Electrical
• Use only original circuit breakers with the prescribed current and voltage ratings.
Switch off the machine immediately when a malfunction in the electrical supply of
the machine is discovered!
• Work done on the electrical equipment or operating materials of the machine
may only be carried out by an electrician or by trained personnel under the
guidance and supervision of an electrician in accordance with the regulations
relating to electrical systems.
• Machine and equipment parts on which inspection, maintenance and repair work
must be done may not carry current or be under voltage when conducting such
work! Switch off the corresponding equipment!
To Next Page