5-2
SPINNER Werkzeugmaschinenfabrik GmbH
SM-1-03/02
5.1 Electrical connection
Main connection:
230V, 50/60Hz is required as the supply voltage. The central connection is carried out by
means of the provided cable.
Push buttons:
Red O: Grinding spindle stop
Green I: Grinding spindle start
Figure 5-1: Main connection
Sockets:
Two sockets are mounted on the rear side of the machine. The machine lamp can be
plugged into the upper socket. The coolant pump can be plugged into the lower socket.
Overload circuit breaker:
An overload circuit breaker for the spindle motor is located beneath the sockets.
Figure 5-2: Sockets
Machine lamp
Coolant pump
To Next Page
Loading...