Spinner SM100 - Page 4

Technical product documentation
4
 SPINNER Werkzeugmaschinenfabrik GmbH
SM-2-12/02
12 CLAMPING PLATE FOR SQUARE TOOLS........................................................... 12-1
12.1 Clamping plate for square tools.........................................................................................................12-2
13 GRINDING THE RADIUS ....................................................................................... 13-1
13.1 Grinding the radius ............................................................................................................................13-2
14 GRINDING THE CUTTER....................................................................................... 14-1
14.1 Grinding the cutter.............................................................................................................................14-2
15 COOLANT UNIT..................................................................................................... 15-1
15.1 Coolant unit .......................................................................................................................................15-2
15.1.1 Recommended coolant ................................................................................................................15-3
16 ACCESSORIES...................................................................................................... 16-1
16.1 Accessories........................................................................................................................................16-2
16.2 Other accessories (if not delivered with the machine) .......................................................................16-3
17 CIRCUIT DIAGRAM................................................................................................ 17-1
17.1 Circuit diagram..................................................................................................................................17-2
18 MICROSCOPE ....................................................................................................... 18-1
18.1 Mikroskope........................................................................................................................................18-2
18.1.1 Axial adjustment of the microscope ............................................................................................18-2
18.1.2 Radial adjustment of the microscope...........................................................................................18-3