A.3.
Flashing New Firmware to the Ranger Converter 3000
Extender
Connect the USB cable to the extender board and select upgrade mode for the extender board. Continue
from step 6.
To flash new firmware:
1. Power on both the Ranger Converter 3000 Board and the Ranger Converter 3000 Extender.
2. Make sure the Ranger Converter 3000 Board and the Ranger Converter 3000 Extender are connected
to each other.Flashing New Firmware to the Ranger Converter 3000 Extender
3. On the Ranger Converter 3000 Board, use the item selectors to scroll to main menu, then select Ext upgrade.
4. Repeat steps 6 through 17 from procedure A.2 Flashing New Firmware to the Ranger Converter 3000 Board.
1. .
To Previous Page
Loading...