Stanley NB08PT-18 - Page 23

6.15.1 Standard tools
NB08PT-18 PB2500Smart
When Smart is disabled
After completing the data reading, you can see
the data stored in the tool like a picture below.
“date_counter_log”  le includes the number of
fastening on a day or in a month. Those can be
seen in Windows Notepad etc. After working,
disconnect the USB cable from the tool.
Data for number of fasteners Do not use
6.15.2 Smart enabled tools
NB08PT-18 PB2500Smart
Not Available
After completing the data reading, you can see
the data stored in the tool like a picture below.
The data until 10,000 are stored in the “10000”
folder, if you open the folder, you can see
folders for each 1,000 data.
“csv.”  les are the data for the rivet curves and
assessment results. You can open the csv  les in
your Microsoft Excel etc.
Copy the  les accordingly. *If you try to copy
a lot of data, it takes much time, please copy
them little by little and you cannot delete the
data in this menu.
Date  le includes the number of fastening on
that a day or in that a month.
After working, disconnect the USB cable from
the tool.
Do not useData for number of rivetingProcess data folder
23
ENGLISH