6.13 COUNTER OPERATION
6.13.1 In case of Poka-Yoke, Service1, Service2, Service3
NB08PT-18 PB2500Smart
After setting, “OK” character is shown in blue
and count up with one-time buzzer.
*If the tool is operated without fastener/
nut, it does not count. There is no “NOK”
judgement.
If the count value reaches a setting value,
“Complete” character is shown in Blue with
Blue background and discontinuous beep.
Operator cannot continue to work for next
riveting without con rming this alarm.
Touch the screen somewhere to clear the
complete alarm.
The screen switches to “Reset conformation”
screen.
Touch “Yes” character string to reset the
counter value, after that operator can
continue to work for next setting.
After rivet setting, if the result is out of OK
range, “NOK” character is shown in Red with
Red background and does not count up the
counter with discontinuous beep.
Operator cannot continue to work for next
riveting without cancelling the error.
Touch the screen somewhere to clear the
error.
*If Smart function is tuned o , “NOK” is not
shown.
Not Available
19
ENGLISH
To Next Page
Loading...
Need help?
General
