Symptom Cause Remedy Page
Tool does not count
correctly (does not
count or counts even if
it does not set rivet).
1. Rivet break load is too small, it is under
2,000N
Counter function cannot be used in
very low break load rivet.
8
2. Riveting cycle is too fast.
Pulled trigger before judgement.
Pull trigger for next riveting after
judgement.
-
3. Setting data are broken Restore to factory settings 31
Rivets / Charge is low. 1. Smart function is turned on. Rivets / Charge decreases, if smart
function is turned on. Turn on/o
smart function as needed.
14
2. Battery is not fully charged Check battery charge level and
charge battery
31 or
Refer to tool
manual
3. Battery is defective Replace battery -
38
ENGLISH
To Next Page
Loading...
Need help?
General
