TS 410, TS 420
English
20
Removing the V-belt guard
N Remove screw(1)
N Raise the V
-
belt guard(2) slightly
and pull it off to the front
N Remove the V-belt(3) from the front
pulley(4)
Remove the "cast arm with guard"
N Unscrew the nuts(1)
N Remove the "starter cover with
rewind starter"(2)
N Remove the "cast arm with
guard"(3) from the studs
Preparing the "cast arm with guard" for
outboard mounting
N Unscrew stop pin(1)
N Turn the guard so that it is in the
position shown (see picture)
N Screw in and tighten the stop pin(1)
N Move the adjusting lever(2) to
positionA
N Screw in the bolt(3) and tighten up
N Unscrew the bolt(4) of the limit
stop(5)
N Remove the limit stop(5)
N Turn the "cast arm with guard" so
that the guard is on the outboard
side
N Insert limit stop(5) – align the hole
in the limit stop with the hole in the
cast arm
N Screw in the bolt(4) and tighten up