28 TS 410, TS 420
: Fit the complete tensioner (1).
– Insert the fastening screws and
tighten them down securely.
The tensioner must be set to the
pre-tensioned position before
installing the cast arm with guard.
Turn the hexagon of the tensioner
as far as possible counterclockwise
to pre-tension the tensioner.
– Tightening torques, b 3.5.
– Reassemble remaining parts in
reverse order.
5.7 Starter cup
: Remove the screw (arrow).
Screw remains in cap.
– Remove the cap (1) with screw.
370RA056 TG
1
370RA102 TG
1
: Remove the spark plug boot (1).
: Unscrew the spark plug (1).
: Push the locking strip (1)
0000 893 5903 as far as possible
into the cylinder.
– Fit the piston.
370RA058 TG
1
370RA059 TG
1
370RA061 TG
1
: Unscrew the nut (arrow) from the
starter cup.
: Pull out starter cup.
– Examine the starter cup, replace
if necessary.
370RA062 TG370RA063 TG
To Next Page
Loading...
