64 TS 410, TS 420
: Slide the starter rope (1) into the
rope rotor (arrow).
– Tie a simple knot in the end of the
starter rope (1) to secure it and
pull it into the rope rotor.
: Press the knot into the mount
(arrow) of the rope rotor.
– Install the rope rotor and tension
the rewind spring, b 9.4, b 9.6.
– Install the starter cover, b 9.2.
– Tightening torques, b 3.5.
1
370RA234 TG370RA235 TG
1
370RA236 TG
9.6 Tensioning the rewind
spring
– Hold the rope rotor (1) so that the
recess (arrow) faces towards the
rope guide.
: Pull the starter rope (2) out
between the recess and rope
guide (arrow) with assembly
hook (3) 5910 890 8800.
Do not damage the starter rope.
: Secure the starter rope (1) in the
recess (arrow) and give the rope
rotor (2) six turns
counterclockwise.
Pawl and spring must be installed.
The rope twists as the rope rotor
and rope are turned. The rewind
spring is now tensioned.
Hold the tensioned rope rotor firmly,
as the rewind spring will be
damaged if it jumps back suddenly.
2
3
370RA237 TG
1
1
2
370RA238 TG
– Hold the rope rotor (2) steady.
: Pull out the rope (1) with the
starter grip and straighten it out.
– Hold the starter grip firmly to keep
the rope (1) tensioned.
: Let the rope rotor go and slowly
rewind the starter rope (1) on the
rope rotor.
2
1
370RA239 TG
370RA240 TG
1
To Next Page
Loading...
