32 TS 410, TS 420
: Press the grooved ball bearing
fully home with press arbor (1)
4224 893 7200.
: Fit the circlip (1).
– Slide the clutch drum (1) into
place.
: Slip on the ring (arrow).
– Tightening torques, b 3.5.
– Reassemble remaining parts in
reverse order.
370RA078 TG
1
370RA079 TG
1
370RA080 TG
1
6.2 Studs for securing the
cast arm with guard
– Remove the cast arm with guard,
b 5.2.
: Fit the stud puller (1)
5910 893 0501 over the stud
(arrows) as far as possible and
unscrew it.
: Coat the thread (arrows) of the
studs with Loctite before fitting
them, b 14.
– Insert the studs and screw them
tight.
– Tightening torques, b 3.5.
– Reassemble remaining parts in
reverse order.
1
370RA081 TG370RA082 TG
To Next Page
Loading...
