37TS 410, TS 420
– Fit the installing sleeve (1)
1118 893 4602.
– Thinly coat the outer
circumference of the oil seal with
sealing compound, b 14.
: Slide the oil seal (2) over the
installing sleeve (1) with the open
side facing the crankcase.
– Remove the installing sleeve (1).
: Press in the oil seal (2) with press
sleeve (1) 4238 893 2400.
– Turn the crankshaft through
several times after approx.
1minute.
– Reassemble remaining parts in
reverse order.
– Tightening torques, b 3.5.
370RA100 TG
1
2
370RA101 TG
1
2
7.4 Removing and installing
the shroud
: Remove the screw (arrow).
Screw remains in cap.
– Remove the cap (1) with screw.
: Pull out the grommet (1).
– Remove the handle molding (2)
and switch shaft (3), b 11.1.1.
: Unhook the throttle rod (1) from
the throttle trigger (2).
370RA102 TG
1
370RA103 TG
1
2
3
370RA104 TG
1
2
– Press the free throttle rod (1) into
the mount (arrow); the throttle rod
is now secure.
: Pull the short circuit and ground
wires out of the guides (arrows).
: Remove the screw (arrow).
– Take out the switch (1) with
retainer.
: Take out the screws (arrows).
– Remove the filter cover (1).
370RA105 TG370RA106 TG
1
1
370RA107 TG
To Next Page
Loading...
