38 TS 410, TS 420
: Take out the screws (arrows).
– Remove the shroud (1).
– Examine the throttle trigger and
trigger interlock, replace if
necessary, b 11.2.
: Fit the shroud (1), guiding the
short circuit and ground wire with
switch through the opening
(arrow).
The wiring harness must be routed
in the guides in the air guide shroud,
b 7.4.
: Insert and tighten down the
screws (arrows).
370RA108 TG
1
370RA109 TG
1
370RA110 TG
– Fit the filter cover (1).
: Insert and tighten down the
screws (arrows).
– Take the throttle rod out of the
mount (arrow).
: Hook the throttle rod (1) into the
throttle trigger (2).
: Slide the switch (1) with retainer
into the mount (arrow).
1
370RA107 TG
370RA112 TG
2
1
370RA113 TG
1
The wires are routed through
underneath the mount.
– Insert and tighten down the
screw.
: First place the short circuit and
ground wires in the guide (1),
then in the other guide (arrow).
– Install the switch shaft and
handle molding, b 11.1.1.
: Press the grommet (1) into the
mount (arrow) until it is fully
home.
370RA114 TG
1
370RA115 TG
1
To Next Page
Loading...
