55TS 410, TS 420
: Ensure that the torsion spring
(arrow) is located in the recess.
– Push the cap back onto the spark
plug boot.
: Use a pointed tool to pierce the
other end of the ignition lead,
which is to be connected to the
ignition module.
– Refit the grommet.
Do not use either graphite grease or
silicone insulating paste.
– Install the ignition module and
adjust the distance between
ignition module and flywheel,
b 8.1.1.
– Reassemble remaining parts in
reverse order.
370RA202 TG370RA203 TG
8.5 Flywheel
– Remove the cap, b 7.4.
– Remove the spark plug.
: Block the piston with the locking
strip (1) 0000 893 5903.
: Remove the flywheel nut (arrow).
: Uniformly screw the screws of the
puller (1) 1135 890 4500 as far as
possible into the holes in the
flywheel until the puller makes
contact.
370RA204 TG
1
307RA205 TG370RA206 TG
1
2
: Turn screw (2) clockwise until the
flywheel comes off the crankshaft
stub.
– Remove the puller (1)
1135 890 4500 with flywheel.
– Take out the screws and remove
the puller from the flywheel.
The flywheel and magnet poles
(arrows) must not display any signs
of damage or discoloration,
otherwise the flywheel must be
replaced.
The hole of the flywheel hub and
crankshaft stub must be grease-free
for installation, b 14.
370RA207 TG
To Next Page
Loading...
