Stihl TS 420 - 10.6 Rubber buffers;support; Support

70 TS 410, TS 420
: Take out the screws (arrows) in
the bottom.
– Remove the clamp (1).
– Remove the handlebar (1).
: Pull out the AV spring (2).
: Remove the clamp (3).
– Check the various parts and
replace if necessary.
: Push the AV spring (1) into the
handlebar so that the tab (2)
engages in the notch (arrow).
370RA270 TG
1
2
3
1
370RA271 TG
1
370RA263 TG
2
: Slide the clamp (1) onto the
handlebar so that the guide (2)
engages in the hole (arrow).
– Position the handlebar (1) over
the machine.
: Push the handlebar (1) into the
mounts (arrows).
The AV spring must be screwed in
as far as possible.
: Push the bearing plug into the
mount (arrow) and hold it in
position.
1
2
370RA272 TG370RA273 TG
1
370RA264 TG
: Insert and tighten down the screw
(arrow).
– Mount the support, b 10.6.
: Fit the clamp (1) so that the peg
engages in the hole (arrow). This
secures the AV spring in the
handlebar.
: Insert and tighten down the
screws (1).
: Insert and tighten down the long
screw (2).
The peg (arrow) must engage in the
hose.
370RA265 TG370RA276 TG
1
370RA277 TG
1
1
2