8 TS 410, TS 420
Bolt P 6x19 Support/ bearing plug AV system 6.0
Bolt P 6x40 Support/ tank housing 6.0
Bolt M 5x48x22 Tank housing / flange 3.5
Bolt M 10x18 Abrasive wheel 30.0
Bolt M 5x30 Adjusting lever / guard 6.0
Bolt M 8x24 Adjusting lever / guard / square nut, drive
side
3.0
Bolt M 8x17 Adjusting lever / guard / square nut, fan
side
3.0
M 14x1.25 Spark plug 28.0
Bolt M 5x20 Ignition module/ crankcase 8.0
Bolt M 4x8 Pan head screw / banjo bolt 3.0
Remarks:
1) Loctite 243 medium strength
2) Connection between crankshaft and flywheel must be degreased and oil-free
When inserting DG and P screws into an existing screw thread:
Insert the DG or P screw in the hole and turn counterclockwise until it gently drops into the hole in axial
direction.
Tighten the screw clockwise to the specified torque.
DG screws must always be tightened with a torque wrench.
This procedure ensures that the screw engages properly in the existing thread and does not form a new thread
and weaken the assembly.
Coat micro-encapsulated screws with Loctite 243 medium strength before refitting them.
Screwdriver speed when used in plastic material: DG and P screws max. 500 rpm.
Do not use an impact wrench to release or tighten screw connections.
Screws with and without locking serration must not be confused.
To Next Page
Loading...
Need help?
General
