Chapter Six – Maintenance Procedures – Siderails
118
6.1 HEAD AND FOOT END SIDERAIL (CONTINUED)
HEAD AND FOOT MOLDED SIDERAIL REPLACEMENT
Required Tools:
#1 or #2 Phillips Screwdriver 5/16” Nut Driver 3/8” Open End Wrench
A
C
B
A
Procedure: (This procedure will take approximately 30 minutes)
1. Unplug the bed power cord from the wall socket.
2. Remove the siderail cover (see page 117).
3. Using a 5/16” nut driver, remove the 5 screws (A) holding the molded rail to the siderail assembly.
NOTE
Notice washer and spacer locations for re–assembly purposes.
4. Pull on the molded rail (B) to remove it from the siderail assembly.
5. Using a 3/8” open end wrench and a 5/16” nut driver, remove the 2 bolts and nuts (C) holding the metal
bracket to the molded rail.
6. Attach the metal bracket to the new molded rail and reverse the above steps to install the new molded rail.
To Next Page
Loading...
