Chapter Four – Maintenance Procedures – Base
73
4.3 STEER WHEEL CABLE REPLACEMENT AND ADJUSTMENT
(STEER CABLE KIT P/N 3000–200–701)
Required Tools:
5/16” Socket Wrench 5/16” Nut Driver
Needle–Nose Vise Grip Pliers Standard Screwdriver
(2) 10mm Open End Wrenches
B
C
D
FOOT END HEAD END
A
Replacement Procedure: (This procedure will take approximately 45 minutes)
1. Unplug the power cord from the wall socket. Remove lower lift cover (see page 67).
2. Remove spring (A).
3. Remove the steer cable (B) from the steer latch lever (C) at the foot end of the bed.
4. Using two 10mm open end wrenches, remove the two jam nuts securing the cable to the cable support
bracket at the head end of the bed on the patient’s right side.
5. Using a 5/16” nut driver, remove the cable clamp (D) holding the cable to the base at the head end of the
bed.
To Next Page
Loading...
