Stryker 3000 - Chapter Five - Maintenance Procedures - Litter; Removal of Litter Access Panels

Chapter Five – Maintenance Procedures – Litter
93
5.1 REMOVAL OF LITTER ACCESS PANELS
(FOOT END LITTER COVER #1 KIT P/N 3000–300–729, LITTER ELECTRICAL COVER #2 KIT P/N
3000–300–721, HEAD END LITTER COVER #3 KIT P/N 3000–300–727, FOWLER MOTOR COVER #4
KIT P/N 3000–300–725, LITTER MID COVER #5 KIT P/N 3000–300–723)
Required Tools:
Standard Screwdriver #2 Phillips Screwdriver
1/4” Nut Driver
NOTE
Before removing the panels, put all siderails down and in the tucked position, run the head section up electri-
cally to approximately 30 and run the knee section fully up. Pull up on the handle on the corner of the foot
section and pivot the foot and knee sections out of the way to allow proper access for removing panels.
1
2
FOOT END
GROUND SCREW
Removal Procedure: (This procedure will take approximately 10 minutes)
1. Unplug the power cord from the wall socket.
2. Lift up on panel #1 to remove it from the foot end of the bed.
NOTE
Panel #1 is secured with dual lock and no tools are necessary for its removal.
3. Using a standard screwdriver, remove the 9 plastic 1/4 turn screws holding panel #2 to the litter at the foot
end of the bed.
4. Using a Phillips screwdriver, remove the ground screw.
5. Lift panel #2 up and out to remove.