Chapter Four – Maintenance Procedures – Base
72
4.2 BRAKE SYSTEM (CONTINUED)
BRAKE SENSOR REPLACEMENT (BRAKE SENSOR SWITCH KIT P/N 3000–200–735)
Required Tools:
5/16” Socket Wrench Side Cutters 5/16” Open End Wrench
HEAD END
A
C
B
D
Procedure: (This procedure will take approximately 25 minutes)
1. Unplug the power cord from the wall socket. Remove lower lift cover (see page 67).
2. Remove the two cables (A) from the switch. (Note the terminals where the cables were connected so the
cables will be reattached properly.)
3. Squeeze the switch retaining clips (B) and push up on the switch to remove it from the retaining bracket.
4. If the retaining bracket is bent or damaged, remove the two screws (C) and the cable tie (D) holding the
bracket to the frame and remove the bracket.
4. Reverse the above steps to install the new bracket and/or switch. Refer to page 63 for switch adjustment,
if necessary.
To Next Page
Loading...
