Chapter Six – Maintenance Procedures – Siderails
122
6.1 HEAD AND FOOT END SIDERAIL (CONTINUED)
HEAD END SIDERAIL CABLE REPLACEMENT (CONTINUED)
E
8. Unplug the cable assembly (E) underneath the head section.
9. Reverse the above steps to install the new cable.
CAUTION
Be sure to position the cables on both sides of the pivot arm, as shown in the illustration on page 121, before
reattaching the pivot arm cover. If not done properly, the cover will not fit tightly and damage could occur to
the cables.
NOTE
If it is more convenient, the siderail can be removed and repairs can be done on a bench (see pages 123 and
124 for siderail assembly removal).
To Next Page
Loading...
