Chapter Four – Maintenance Procedures – Base
74
4.3 STEER WHEEL CABLE REPLACEMENT AND ADJUSTMENT (CON-
TINUED)
D
5. Using a 1/4” nut driver and needle–nose vise grip pliers, loosen the bolt head in the cable retainer (D) and
slide the retainer off the cable. Pull the cable out of the bed.
NOTE
If the cable sheathing is not damaged, pull the cable from the head end of the bed and remove it from the
sheathing, leaving the sheathing on the bed. Push the new cable through the sheathing from the head end.
6. Reverse the above steps to attach the new cable.
To Next Page
Loading...
