Chapter Four – Maintenance Procedures – Base
75
4.3 STEER WHEEL CABLE REPLACEMENT AND ADJUSTMENT (CON-
TINUED)
E
3/16”
Adjustment Procedure: (This procedure will take approximately 20 minutes)
If the steer wheel engages when the steer pedal is in the neutral or off position, slide the cable retainer (item
(D), page 74) toward the cable support bracket and tighten the retainer back down on the cable.
If the steer wheel does not hold properly when the pedal is in the steer position, slide the retainer away from
the cable support bracket and tighten the retainer back down on the cable.
NOTE
The ideal off position for the steer latch lever (E) to the steer wheel is approximately 3/16” between the end
of the lever and the caster horn.
To Next Page
Loading...
