Stryker 3000 - Page 67

Chapter Four – Maintenance Procedures – Base
67
4.1 BASE COVER REMOVAL
UPPER LIFT COVER REMOVAL (UPPER LIFT COVER KIT P/N 3000–200–739)
Required Tools:
#2 Phillips Screwdriver Bungee Cord (or equivalent)
Removal Procedure: (This procedure will take approximately 5 minutes)
1. Unplug the power cord from the wall socket. Using a Phillips screwdriver, remove the 3 screws holding
the upper lift cover (A) to the base (as shown in the illustration).
2. Lift up the cover. If desired, hold the cover out of the way by using bungee cords or the equivalent to secure
it to the litter top.
3. Reverse the above steps to reattach the cover.
LOWER LIFT COVER REMOVAL
(LOWER LIFT COVER KIT P/N 3000–200–747)
Required Tools:
5/16” Socket Wrench
Removal Procedure: (This procedure will take approximately 5 minutes)
1. Unplug the power cord from the wall socket. Using a 5/16” socket, remove the 6 screws holding the lower
lift cover (B) to the base (as shown in the illustration).
2. Lower the cover away from the base and set it aside.
WARNING
The lift motor is not grounded and may present electrical hazard. Use caution when working around motors.
3. Reverse the above steps to reattach the cover. Be sure the manual override shaft is aligned with the hole
in the lower lift cover.
NOTE
The procedure for removing the lift covers is the same for both ends of the bed.
A
B
FOOT END