Stryker Prime Series User Manual

CCoonnvveerrttiinngg tthhee ddeeffiibbrriillllaattoorr ttrraayy//ffoooott eexxtteennddeerr ttoo aa ddeeffiibbrriillllaattoorr ttrraayy
WWAARRNNIINNGG
• Do not place items that weigh more than 30 lb (14 kg) on the defibrillator tray/foot extender. Always strap down all
devices that you place on the defibrillator tray.
• Always use caution if the defibrillator tray/foot extender, footboard/chart holder, or upright oxygen bottle holder is
attached to avoid pinching your fingers when you position the foot end push handle option.
CCAAUUTTIIOONN -- Always raise the IV pole before you attach the defibrillator tray/foot extender to the product. If you do not raise
the IV pole, the foot extender will not operate.
To convert the defibrillator tray/foot extender to a defibrillator tray:
1. Pull out the top knob (A) (Figure 24).
2. Pivot the defibrillator tray (B) until the tray is flat over the foot end of the product. Release the top knob (A). Make sure
that the defibrillator tray is locked in place.
3. Use the strap to secure devices to the defibrillator tray.
NNoottee
• Do not use the defibrillator tray/foot extender as a push/pull device. Product damage may occur.
• Do not attach items to the foot extender.
A
B
C
D
FFiigguurree 2244 –– DDeeffiibbrriillllaattoorr ttrraayy//ffoooott eexxtteennddeerr
CCoonnvveerrttiinngg tthhee ddeeffiibbrriillllaattoorr ttrraayy//ffoooott eexxtteennddeerr ttoo aa ffoooott eexxtteennddeerr
WWAARRNNIINNGG
• Do not place items that weigh more than 30 lb (14 kg) on the defibrillator tray/foot extender. Always strap down all
devices that you place on the defibrillator tray.
• Always use caution if the defibrillator tray/foot extender, footboard/chart holder, or upright oxygen bottle holder is
attached to avoid pinching your fingers when you position the foot end push handle option.
CCAAUUTTIIOONN -- Always raise the IV pole before you attach the defibrillator tray/foot extender to the product. If you do not raise
the IV pole, the foot extender will not operate.
To convert the defibrillator tray/foot extender to a foot extender (Figure 24):
1. Pull out the top knob (A).
1115-309-001 Rev AD.0 43 EN

Stryker Prime Series Specifications

General

Model	Prime Series
Category	Medical Equipment
Power Requirements	120V AC, 60Hz
Battery Backup	Yes
Type	Medical Bed
Weight Capacity	500 lbs
Features	integrated scale
Compatibility	Compatible with Stryker