Stryker Prime Series User Manual

CClleeaanniinngg aanndd ddiissiinnffeeccttiinngg wwiitthh SSiiddeeKKiicckk
For United States only. Confirm availability for your configuration or region. Call Stryker Customer Service: 1-800-327-
0770.
Stryker’s preferred spray (2070-000-001) and 6'' x 10'' wipes (2060-000-001) include the following active ingredients:
• n-Alkyl (60% C14, 30% C16, 5% C12, 5% C18) dimethyl benzyl ammonium chloride - 0.154%
• n-Alkyl (68% C12, 32% C14) dimethyl ethylbenzyl ammonium chloride - 0.154%
• Isopropanol - 21.000%
Non-active ingredient: Ethylene Glycol Monobutyl Ether – < 3%
NNoottee -- For safety information, read the product label.
TToo cclleeaann oorr ddiissiinnffeecctt tthhee eexxtteerrnnaall pprroodduucctt ssuurrffaaccee wwiitthh SSiiddeeKKiicckk wwiippee::
TToo cclleeaann::
1. Wipe down the external product surface with a fresh,
clean wipe to remove all visible soils.
2. Repeat as necessary until the external product surface
is visibly clean.
3. Wipe dry with a cloth or allow the external product
surface to air dry before you return the product to
service.
NNoottee -- Use as many wipes as necessary.
TToo ddiissiinnffeecctt::
1. Clean first.
2. Wipe down the external product surface with a fresh,
clean wipe until wet.
3. Allow the external product surface to remain wet for two
minutes at room temperature.
4. Wipe dry with a cloth or allow the external product
surface to air dry before you return the product to
service.
TToo cclleeaann oorr ddiissiinnffeecctt tthhee eexxtteerrnnaall pprroodduucctt ssuurrffaaccee wwiitthh SSiiddeeKKiicckk sspprraayy::
TToo cclleeaann::
1. Spray SSiiddeeKKiicckk on a mop, sponge, paper cloth, or cloth
towel.
2. Wipe down the external product surface with a fresh,
clean mop, sponge, paper cloth, or cloth towel to
remove all visible soils.
3. Repeat as necessary until the external product surface
is visibly clean.
4. Wipe dry with a cloth or allow the external product
surface to air dry before you return the product to
service.
TToo ddiissiinnffeecctt::
1. Clean first.
2. Spray SSiiddeeKKiicckk on a mop, sponge, paper cloth, or cloth
towel.
3. Wipe down the external product surface with a fresh,
clean mop, sponge, paper cloth, or cloth towel until wet.
4. Allow the external product surface to remain wet for two
minutes at room temperature.
5. Wipe dry with a cloth or allow the external product
surface to air dry before you return the product to
service.
NNoottee -- Follow your hospital protocols to launder cloth towels or dispose of wipes or paper cloths.
EN 54 1115-309-001 Rev AD.0

Stryker Prime Series Specifications

General

Model	Prime Series
Category	Medical Equipment
Power Requirements	120V AC, 60Hz
Battery Backup	Yes
Type	Medical Bed
Weight Capacity	500 lbs
Features	integrated scale
Compatibility	Compatible with Stryker