Micro Series
Micro Series 1-45
Document generated:29.06.17
SW V1.1
processing are found.
[4] Phase Inverts the mono signal or the left channel of the stereo signal if turned On.
[5] Input calibration This fader allows the operator to trim the signal by +/-18dB
On stereo channels, in this section also a Mono button can be found. This
button downmixes the stereo signal to mono : Mono=(Left+Right)-3dB
[6] Reset This button sets all values of this processing block to the default values. Please
note that this button can be found on every tab of the channel config page.
To Next Page
Loading...
