Micro Series
1-56 Micro Series
Document generated: 29.06.17
SW V1.1
The config page of the AUX busses Send section holds control elements
necesarry to set the actual send levels of contributing channels - e.g. to set
the mix.
[2]
[7]
[5]
[4]
[6]
[3]
[1]
[1] Pre/Post Lets the user decide whether the signal should be sent to the Aux bus either
before or after the channals fader. “Pre” stands for before the fader, “Post”
stands for after the fader.
[2] Send levels These are the send levels of all input channels to the currrently chosen bus.
[3] Send On/Off Each source has an individual On/Off button to assign the channel to the Aux
bus.
[5] Master Send level Sets the output level of the send bus.
[4] On/Off Switches the output signal of the send bus on and off.
[6] Bus Mode Lets the user select the bus mode that can either be N-1 or Aux.
N-1 : this mode is made for busses that are feeding a return signal to remote
positions. This mode doesn’t allow the input signal of the remote source
to be assigned to the bus. With this bus mode, the remote source (e.g. a
reporter) will never have his own signal in his return feed. This is opti-
mal to prevent echo’s that could be introduced through long distance
signal transmission.
Aux : this is the bus mode that allows all sources to be assigned to the
bus . The user can decide whether the signal should be sent to the bus
either before or after the channals fader. This can be set for each source
individually by chosing Pre or Post with the button on the top. Also each
source has an individual on/off button to select the desired bus assign.
[7] Reset Resets all parameters.
To Next Page
Loading...
