Chapter 1 Introduction 1-9
FIGURE 1-4 Location of Front Panel Features (Sun Fire V240 Server)
1.2.6 On/Standby Switch
Access to the On/Standby switch is by opening the front bezel. The On/Standby
switch controls only the power state of the server, it does not isolate the server from its
electrical power source.
The On/Standby switch is a momentary switch and has two operation modes:
■ Press and immediately release
■ Press and hold down for more than 4 seconds
The results of these actions are summarized in TABLE 1-3.
System configuration card
DVD-ROM drive
Hard drive
On/Standby switch
Keyswitch
To Next Page
Loading...
