Sun Microsystems Fire V210 - Prtconf Command

6-18 Sun Fire V210 and V240 Servers Administration Guide • December 2005
6.7.2.1 prtconf command
The prtconf command displays the Solaris device tree. This tree includes all the
devices probed by OpenBoot firmware, as well as additional devices, like individual
disks, that only the operating system software can detect. The output of prtconf
also includes the total amount of system memory.
CODE EXAMPLE 6-5 shows an
excerpt of prtconf output.
CODE EXAMPLE 6-5 prtconf Command Output
The prtconf command’s -p option produces output similar to the OpenBoot
show-devs command. This output lists only those devices compiled by the system
firmware.
# prtconf
System Configuration: Sun Microsystems sun4u
Memory size: 1024 Megabytes
System Peripherals (Software Nodes):
SUNW,Sun-Fire-V240
packages (driver not attached)
SUNW,builtin-drivers (driver not attached)
deblocker (driver not attached)
disk-label (driver not attached)
terminal-emulator (driver not attached)
dropins (driver not attached)
kbd-translator (driver not attached)
obp-tftp (driver not attached)
SUNW,i2c-ram-device (driver not attached)
SUNW,fru-device (driver not attached)
ufs-file-system (driver not attached)
chosen (driver not attached)
openprom (driver not attached)
client-services (driver not attached)
options, instance #0
aliases (driver not attached)
memory (driver not attached)
virtual-memory (driver not attached)
SUNW,UltraSPARC-IIIi (driver not attached)
memory-controller, instance #0
SUNW,UltraSPARC-IIIi (driver not attached)
memory-controller, instance #1 ...