Chapter 6 Diagnostics 6-9
Note – If you have a PCI card installed in the server, then additional tests are
displayed on the OBDiag menu.
3. Type:
Where n represents the number corresponding to the test you want to run.
A summary of the tests is available. At the obdiag> prompt, type:
6.5.2 Controlling OpenBoot Diagnostics Tests
Most of the OpenBoot configuration variables you use to control POST (see TABLE 6-2
on page 7) also affects OpenBoot Diagnostics tests.
■ Use the diag-level variable to control the OpenBoot Diagnostics testing level.
■ Use test-args to customize how the tests run.
By default, test-args is set to contain an empty string. You can modify test-
args using one or more of the reserved keywords shown in
TABLE 6-4.
TABLE 6-3 Sample obdiag menu
obdiag
1 flashprom@2,0
4 network@2
7 scsi@2
10 serial@0,3f8
2 i2c@0,320
5 network@2,1
8 scsi@2,1
11 usb@a
3 ide@d
6 rtc@0,70
9 serial@0,2e8
12 usb@b
Commands: test test-all except help what setenv set-default exit
diag-passes=1 diag-level=max test-args=subtests, verbose
obdiag> test n
obdiag> help
To Next Page
Loading...
Need help?
General
