6-16 Sun Fire V210 and V240 Servers Administration Guide • December 2005
6.6.4 To Run OpenBoot Commands
Caution – If you used the halt command or the Stop-A key sequence to reach the
ok prompt, then issuing the probe-scsi command can hang the system.
1. Halt the system to reach the ok prompt.
How you do this depends on the system’s condition. If possible, you should warn
users before you shut the system down.
2. Type the appropriate command at the console prompt.
/pci@1e,600000/isa@7/i2c@0,320/motherboard-fru-prom@0,a2
/pci@1e,600000/isa@7/i2c@0,320/12c-bridge@0,18
/pci@1e,600000/isa@7/i2c@0,320/12c-bridge@0,16
/pci@1f,700000/network@2,1
/pci@1f,700000/network@2
/openprom/client-services
/packages/obdiag-menu
/packages/obdiag-lib
/packages/SUNW,asr
/packages/SUNW,fru-device
/packages/SUNW,12c-ram-device
/packages/obp-tftp
/packages/kbd-translator
/packages/dropins
/packages/terminal-emulator
/packages/disk-label
/packages/deblocker
/packages/SUNW,bultin-drivers
{1} ok
CODE EXAMPLE 6-4 show-devs Command Output (Continued)
To Next Page
Loading...
