Sun Microsystems Fire V210 User Manual

Chapter 6 Diagnostics 6-5
6.4.1 To Start POST Diagnostics—Method 1
There are two methods for starting POST diagnostics. In the following procedures
both methods are described.
1. Go to the ok prompt.
2. Type:
3. Type:
Where value is either min or max depending on the desired range coverage.
4. Power cycle the server.
After you have powered the server off, wait 60 seconds before powering the server
on. POST executes after the server is powered on.
Note – Status and error messages could be displayed in the console window. If
POST detects an error, it displays an error message describing the failure.
5. When you have finished running POST, restore the value of diag-switch? to
false by typing:
Resetting diag-switch? to false minimizes boot time.
6.4.2 To Start POST Diagnostics—Method 2
1. Go to the ok prompt.
2. Type:
ok setenv diag-switch? true
ok setenv diag-level value
ok setenv diag-switch? false
ok setenv diag-switch? false

Sun Microsystems Fire V210 Specifications

General

Brand	Sun Microsystems
Model	Fire V210
Category	Server
Language	English