76
11
Routine Maintenance
11.1 Safety Instructions
Risk of inverter damage or personal injury due to incorrect service!
• Disconnect the switches between the product and all power supplies before
maintenance.
• After the inverter is powered off for 5 minutes, measure the voltage and current
with measuring equipment. Only when there is no voltage nor current can oper-
ators who wear protective equipment operate and maintain the inverter.
The devices inside the inverter carry high voltage. Touching these devices may
lead to fatal electric shock.
Therefore,
• Live line measurement can only be performed by professional personnel who
know the PV system well. Before measurement, be sure to take proper protec-
tion methods (e.g., wear insulating gloves, etc.).
• During live line measurement, the operator must be accompanied by others to
ensure personal safety.
Electric shock or fire may occur due to device damage or system fault.
• Visually inspect for device damages or other hazards before the operation
• Check whether other external devices or circuit connections are in a safe state.
• Make sure the device is in a safe state before operating.
To Next Page
Loading...
Need help?
General