76
(2) Clicking “LEVER POSITION (XXXXXX)” button from the Setup Change dialog box displays the follow-
ing window:
Set the lever to each position (Forward, Neutral, Reverse) and click the “Set” button.
If the set lever positions are correctly registered, “✓ ” mark is displayed in the “Status” column in the
right side of the window.
Repeat the same operation to register all the lever positions.
Clicking the “Cancel” button cancels system setting change.
(3) When all the lever positions have been regis-
tered, return the lever to the neutral position.
To Next Page
Loading...
