1F-6 Engine Cooling System:
Radiator Cleaning
Blow out any foreign matter that is stuck in the radiator
fins using compressed air.
CAUTION
!
• Make sure not to bend the fins when using
compressed air.
• If compressed air is applied from the front
side, dirt will be forced into the pores of
radiator.
1) Remove the frame body covers. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)”.
2) Disconnect the cooling fan motor couplers (1).
3) Remove the radiator mounting bolts (2).
4) Move the radiator forward.
5) Always apply compressed air from the engine side.
6) Reinstall the removed parts.
Radiator / Cooling Fan Motor Removal and
Installation
B823H11606004
Removal
1) Remove the frame body covers (1) and under
cowling (2). Refer to “Exterior Parts Removal and
Installation in Section 9D (Page 9D-14)”.
2) Drain engine coolant. Refer to “Cooling System
Inspection in Section 0B (Page 0B-13)”.
3) Disconnect the radiator inlet hose (3), reservoir tank
hose (4), water air bleed hose (5) and cooling fan
motor coupler (right) (6).
4) Disconnect the cooling fan motor coupler (left) (7)
and radiator outlet hose (8).
1
1
I823H1160054-01
2
2
2
I823H1160055-02
I823H1160056-01
1
2
I823H1160008-01
3
5
6
4
I823H1160009-01
7
8
I823H1160010-01
To Next Page
Loading...
Need help?
General
