1H-14 Ignition System:
Drive Mode Selector Inspection
B823H11806010
Inspect the drive mode selector in the following procedures:
1) Set up the SDS tool. (Refer to the SDS operation manual for further details.)
2) Turn the ignition switch ON.
3) Click “Date monitor”.
4) Make sure each of “Driving mode selection” on the monitor is indicated “Open”.
5) Push each of drive mode selector A (1) and B (2). At this time, if the indication is changed to “GND”, the function is
normal.
I823H1180029-02
2
1
I823H1180030-03
To Next Page
Loading...
