Suzuki GSX1300BK B-King - Engine Coolant Temperature Indicator and Indicator Light Inspection

9C-4 Combination Meter / Fuel Meter / Horn:
2) With the adjuster button (1) pressed, turn the ignition
switch ON.
3) Keep pushing the ADJ button for more than 3 sec.
Pointer will return to the starting point right after the
completion of the operation. In the case of the
pointer not returning to the proper position after
doing above, replace the combination meter unit.
Refer to “Combination Meter Removal and
Installation (Page 9C-2)”.
Engine Coolant Temperature Indicator and
Indicator Light Inspection
B823H19306005
Inspect the engine coolant temperature indicator light in
the following procedures:
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
10)”.
2) Disconnect the ECT sensor coupler (1).
3) Connect a variable resistor (2) between the
terminals.
km/h
3
2
4
5
6
7
8
9
10
11
12
1
0
x
1
00
0
r/m
i
n
1
I823H1930005-03
Time Ignition switch Adjuster button (1)
PUSH
Reset
OFF
ON
0
•
•
•
•
•
•
3 sec.
•
•
I823H1930031-04
1
I823H1110116-01
2
I718H1930009-05