Suzuki GSX1300BK B-King - EXCV Inspection; Exhaust System Inspection; Specifications; Service Data

Exhaust System: 1K-15
• Route the HO2 sensor lead wire properly. Refer to
“Wiring Harness Routing Diagram in Section 9A
(Page 9A-5)”.
• Install EXCV cables and EXCV cover. Refer to “EXCV
Cable Removal and Installation (Page 1K-5)”.
• Tighten each bolt to the specified torque. Refer to
“Exhaust System Components (Page 1K-4)”.
Exhaust System Inspection
B823H11B06003
Inspect the exhaust pipe connection and muffler
connection for exhaust gas leakage and mounting
condition. If any defect is found, replace the exhaust
pipe assembly or muffler with a new one.
Check the exhaust pipe bolts, muffler connecting bolts
and muffler mounting bolts are tightened to their
specified torque.
Refer to “Exhaust Pipe Bolt and Muffler Bolt Inspection
in Section 0B (Page 0B-3)”.
EXCV Inspection
B823H11B06004
Inspect the EXCV in the following procedures:
1) Remove the exhaust pipe assembly. Refer to
“Muffler / Muffler Joint / Exhaust Pipe Removal and
Installation (Page 1K-12)”.
2) Turn the lever (1) and inspect that the EXCV (2)
moves smoothly. If it does not moves smoothly,
replace the exhaust pipe assembly with a new one.
CAUTION
!
• Do not attempt to disassemble the EXCV.
• The EXCV is available only as the exhaust
pipe assembly.
3) Decarbonize the EXCV if necessary.
4) Install the exhaust pipe assembly. Refer to “Muffler /
Muffler Joint / Exhaust Pipe Removal and Installation
(Page 1K-12)”.
Specifications
Service Data
B823H11B07001
FI Sensors
Tightening Torque Specifications
B823H11B07002
NOTE
The specified tightening torque is also described in the following.
“Exhaust Control System Construction (Page 1K-3)”
“Exhaust System Components (Page 1K-4)”
1
2
I823H11B0042-01
Item Standard/Specification Note
EXCVA position sensor output
voltage
Closed 0.45 – 1.4 V
Opened 3.6 – 4.55 V
Fastening part
Tightening torque
Note
Nmkgf-mlb-ft
EXCV cable bracket nut 10 1.0 7.0 )(Page 1K-7)
EXCV cover bolt
10 1.0 7.0
)(Page 1K-7) /
)(Page 1K-9)
EXCVA pulley mounting bolt 5 0.5 3.5 )(Page 1K-8)
EXCVA mounting bolt 10 1.0 7.0 )(Page 1K-9)
HO2 sensor 25 2.5 18.0 )(Page 1K-14)