4A-18 Brake Control System and Diagnosis:
Specifications
Service Data
B823H14107001
Brake
Unit: mm (in)
Tightening Torque Specifications
B823H14107002
NOTE
The specified tightening torque is also described in the following.
“Front Brake Hose Routing Diagram (Page 4A-1)”
“Rear Brake Hose Routing Diagram (Page 4A-2)”
“Front Brake Master Cylinder Components (Page 4A-9)”
“Rear Brake Master Cylinder Components (Page 4A-13)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-9)”.
Item Standard Limit
Rear brake pedal height 55 – 65 (2.2 – 2.6) —
Master cylinder bore
Front 19.050 – 19.093 (0.7500 – 0.7517) —
Rear 12.700 – 12.743 (0.5000 – 0.5017) —
Master cylinder piston diam.
Front 19.018 – 19.034 (0.7487 – 0.7494) —
Rear 12.657 – 12.684 (0.4983 – 0.4994) —
Brake fluid type DOT 4 —
Fastening part
Tightening torque
Note
Nmkgf-mlb-ft
Air bleeder valve (Front)
60.6 4.5
)(Page 4A-5) /
)(Page 4A-7)
Air bleeder valve (Rear)
7.5 0.75 5.5
)(Page 4A-6) /
)(Page 4A-8)
Master cylinder holder bolt (Upper and Lower) 10 1.0 7.0 )(Page 4A-10)
Brake hose union bolt
23 2.3 16.5
)(Page 4A-10) /
)(Page 4A-14)
Air bleeder valve (Master cylinder) 6 0.6 4.5 )(Page 4A-10)
Brake lever pivot bolt 1 0.1 0.7 )(Page 4A-12)
Brake lever pivot bolt lock-nut 6 0.6 4.5 )(Page 4A-12)
Rear brake master cylinder mounting bolt 10 1.0 7.0 )(Page 4A-14)
Rear brake master cylinder rod lock-nut 18 1.8 13.0 )(Page 4A-14)
To Next Page
Loading...
