EasyManua.ls Logo

Suzuki GSX1300BK B-King - Cooling System Inspection; Evaporative Emission Control System Inspection (E-33 Only); PAIR System Inspection

Suzuki GSX1300BK B-King
686 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0B-13 Maintenance and Lubrication:
Evaporative Emission Control System
Inspection (E-33 only)
B823H10206008
Inspect evaporative emission control system
Every 12 000 km (7 500 miles, 24 months)
Inspect the evaporative emission control system
periodically (E-33 only).
PAIR System Inspection
B823H10206012
Inspect PAIR system
Every 12 000 km (7 500 miles, 24 months)
Inspect the PAIR (air supply) system periodically. Refer
to “PAIR System Inspection in Section 1B (Page 1B-11)”.
Cooling System Inspection
B823H10206013
Inspect cooling system
Every 6 000 km (4 000 miles, 6 months)
Replace engine coolant
Every 2 years
Engine Coolant Level Inspection
1) Hold the motorcycle vertically.
2) Check the engine coolant level by observing the full
and lower lines on the engine coolant reservoir tank.
If the level is below the lower line, add engine
coolant to the full line from the engine coolant
reservoir tank filler (1) behind the right frame side
cover. Refer to “Exterior Parts Removal and
Installation in Section 9D (Page 9D-14)”.
Engine Coolant Change
Refer to “Engine Coolant Description in Section 1F
(Page 1F-1)”.
WARNING
!
Do not open the radiator cap when the engine
is hot, as you may be injured by escaping hot
liquid or vapor. Engine coolant may be
harmful if swallowed or if it comes in contact
with skin or eyes. If engine coolant gets into
the eyes or in contact with the skin, flush
thoroughly with plenty of water. If swallowed,
induce vomiting and call physician
immediately.
1) Remove the right frame body cover. Refer to
“Cooling Circuit Inspection in Section 1F (Page 1F-
4)”.
2) Remove the radiator cap (1).
3) Remove the under cowling. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)”.
4) Drain engine coolant by disconnecting the water
pump inlet hose (2).
5) Flush the radiator with fresh water if necessary.
6) Reconnect the water pump inlet hose.
7) Pour the specified engine coolant up to the radiator
inlet.
Engine coolant capacity (excluding reservoir)
2 650 ml (2.8/2.3 US/lmp qt)
8) Bleed air from the cooling circuit.
L
F
I823H1020031-02
1
I823H1020063-01
1
I823H1020043-01
2
I823H1020044-01

Table of Contents

Related product manuals