Suzuki GSX1300BK B-King - Starter Torque Limiter; Starter Clutch Removal and Installation

1I-10 Starting System:
7) Measure the voltage between R and B lead wires
using the multi-circuit tester when shifting the
gearshift lever from low to top.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
(B): 09900–25009 (Needle pointed probe
set)
Tester knob indication
Voltage ( )
Gear position switch voltage (Except neutral
position)
0.6 V and more ((+) R – (–) B)
8) Turn the ignition switch OFF.
9) Install the left frame cover. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)”.
Starter Torque Limiter / Starter Clutch Removal
and Installation
B823H11906009
Removal
1) Drain engine oil.
2) Remove the starter torque limiter cover (1).
3) Remove the gasket (2) and dowel pins.
4) Remove the starter torque limiter (3) and shaft (4).
5) Remove the starter clutch cover (5).
6) Remove the gasket (6) and dowel pins.
7) Remove the wave washer (7), starter idle gear (8)
and shaft (9).
(A)
(B)
I823H1190017-01
1
I823H1190018-01
2
3
4
I823H1190019-01
5
I823H1190020-01
7
8
9
6
I823H1190021-02