Engine Mechanical: 1D-72
Oil Gallery Plug
1) Remove the oil gallery plug (M6) (1), (M14) (2),
(M14) (3) and (M6) (4) from the upper crankcase.
2) Remove the oil gallery plugs (M6) (5), (M8) (6),
(M10) (7), (M6) (8) and (M16) (9) from the lower
crankcase.
Bearing
Remove the bearings if necessary. Refer to “Gearshift
Shaft Oil Seal / Bearing Removal and Installation in
Section 5B (Page 5B-17)”.
Engine Bottom Side Assembly
B823H11406035
Assemble the engine bottom side in the reverse order of
disassembly. Pay attention to the following points:
NOTE
Apply engine oil to each running and sliding
part before reassembling.
Oil Seal / Bearing
• Install the oil bearings. Refer to “Gearshift Shaft Oil
Seal / Bearing Removal and Installation in Section 5B
(Page 5B-17)”.
Oil Gallery Plug
• Tighten each plug to the specified torque.
CAUTION
!
Replace the gaskets with new ones.
1
I823H1140451-01
2
3
I823H1140452-01
4
I823H1140453-01
5
I823H1140454-01
6
7
8
9
I823H1140455-01
To Next Page
Loading...
