3-68 ENGINE
GENERATOR ROTOR COVER
• Before installing the starter idle gear, apply molybdenum oil
solution to the hole of starter idle gear shaft.
P MOLYBDENUM OIL SOLUTION
• Install the starter idle gear
1
, shaft
2
, dowel pins and gasket
3
.
• Tighten the generator rotor cover bolts to the specified torque.
" Generator rotor cover bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
MOVABLE DRIVEN
• Install the movable drive spacer
1
and movable drive face
assembly
2
.
• Install the drive belt
3
to the movable driven face
4
.
NOTE:
With the clutch shoe spring compressed by hands, install the
drive belt 3 between the movable driven face 4 and fixed
driven face.
The removed gasket must be replaced with a new one
to prevent oil leakage.
* Degrease the drive belt contact surface (pulley face).
* Position the drive belt so that the arrow A points the
engine rotating direction.
To Next Page
Loading...
