PERIODIC MAINTENANCE 2-23
STEERING
Steering system should be adjusted properly for smooth manip-
ulation of the handlebar and safe running.
TOE-IN
• Place the vehicle on level ground.
• Make sure the tire pressure for both tire is the same and set to
the proper specification.
• Set the front wheels in the straight position.
• Place a load of 63 kg (139 lbs) on the seat.
• Measure the distance
A
and
B
of the front wheels, with a
toe-in gauge as shown and calculate the difference between
A
and
B
.
B
–
A
= Toe-in
Toe-in: 4.5 ± 3 mm (0.17 ± 0.1 in)
• If the toe-in is out of specification, bring it into the specified
range. (
5-32)
SUSPENSIONS
• Support the vehicle with a jack and wooden blocks.
• Remove the front and rear wheels. (
5-8)
• Inspect the suspension arm, swingarm and bush for
scratches, wear or defect. If any defects are found, replace
them with new ones. (
5-23 and 5-50)
• Inspect the front and rear shock absorbers for oil leakage or
defects. If any defects are found, replace them with new ones.
(
5-23 and 5-49)
Inspect initially at 1 month and every 3 months there-
after.
Forward
Inspect every 6 months.
To Next Page
Loading...
