5-52 CHASSIS
CHAIN BUFFER
Inspect the chain buffer for wear and damage. If any defects are
found, replace the chain buffer with a new one.
REASSEMBLY AND INSTALLATION
Reassemble and install the rear suspension in the reverse order
of removal and disassembly. Pay attention to the following
points:
• Press the bearing into the rear shock absorber to the depth of
4 mm (0.157 in) with the special tool and suitable socket
wrench.
\ 09924-84521: Bearing installer set
• Apply SUZUKI SUPER GREASE “A” to lip of the dust seals
and collars.
X 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Install the dust seals
1
and collars
2
into the rear shock
absorber.
The removed bearing must be replaced with a new
one.
The removed dust seals must be replaced with new
ones.
To Next Page
Loading...
