3-62 ENGINE
ENGINE REASSEMBLY
Reassemble the engine in the reverse order of disassembly. The following steps require special attention or
precautionary measures should be taken.
NOTE:
Apply engine oil to each running and sliding part before reassembling.
CRANKSHAFT
• Determine the width between the webs referring to the figure
when rebuilding the crankshaft.
Crank-web-to-web-width
Standard: 49 ± 0.1 mm (1.929 ± 0.003 in)
• When mounting the crankshaft in the crankcase, it is neces-
sary to pull its left end into the crankcase with the special
tools.
\ 09910-32812: Crankshaft installer
09911-11310: Attachment
09913-70210: Bearing installer set (¬ 35)
1
Bearing
4
Conrod
7
Crankshaft (L)
2
Sim
5
Bearing
8
Bearing
3
Crankshaft (R)
6
Crank pin
To Next Page
Loading...
