5-28 CHASSIS
REASSEMBLY AND INSTALLATION
Reassemble and install the steering in the reverse order of
removal and disassembly. Pay attention to the following points:
• Install the steering shaft bush with the special tool and suit-
able size socket wrench.
\ 09924-84521: Bearing installer set
STEERING SHAFT
• Apply RESISTANCE GREASE to the steering shaft lower
dust seal
1
O-ring
2
and steering shaft
3
.
99000-25160: SUZUKI RESISTANCE GREASE
(or equivalent)
• Install the steering shaft lower dust seal
1
and O-ring
2
to
the steering shaft
3
.
• Tighten the steering shaft lower nut to the specified torque
and install the cotter pin.
" Steering shaft lower nut: 35 N·m (3.5 kgf·m, 25.5 Ib-ft)
The removed steering shaft bush must be replaced
with a new one.
To prevent the entry of dirt, the dust seal end A must
face forward when installed on the steering shaft 3.
The removed cotter pin must be replaced with a new
one.
To Next Page
Loading...
