2-12 PERIODIC MAINTENANCE
OIL STRAINER INSPECTION AND CLEANING
• Drain the engine oil as descried in the engine oil replacement
procedure.
• Remove the oil strainer cap
1
and oil strainer
2
.
• Clean the oil strainer with compressed air also check the oil
strainer for wear and damage. If any defects are found,
replace it with a new one.
FINAL REDUCTION GEAR BOX OIL
FINAL REDUCTION GEAR BOX OIL REPLACEMENT
• Place the vehicle on level ground.
• Remove the left footrest mudguard. (
5-5)
• Remove the front cooling duct connector
1
and rear cooling
duct connector
2
.
• Remove the crankcase cover
3
.
• Remove the oil filler cap
4
.
• Remove the drain plug
5
and drain the oil into an oil pan.
• Reinstall the drain plug
5
.
• Pour new oil through the oil filler hole until the oil flows from oil
filler hole.
• Reinstall the oil filler cap
5
.
Final reduction gear box oil capacity:
Oil change: 90 ml (3.0/3.2 US/Imp oz)
Overhaul: 100 ml (3.4/3.5 US/Imp oz)
Inspect every 6 months.
Replace every 2 years.