ENGINE 3-75
CAM CHAIN TENSION ADJUSTER
• Apply engine oil to the push rod.
• Turn the adjusting screw clockwise with a
-
screwdriver until
the rod locked.
• Install the cam sprocket
3
.
• Apply a small quantity of THREAD LOCK SUPER “1322” to
the cam sprocket bolt
4
.
H99000-3208: THREAD LOCK SUPER “1322”
• Tighten the cam sprocket bolt to the specified torque.
" Cam sprocket bolt: 11 N·m (1.1 kgf-m, 8 lb-ft)
• Install the gasket
1
and cam chain tension adjuster
2
to the
cylinder.
• Tighten the cam chain tension adjuster mounting bolts to the
specified torque.
" Cam chain tension adjuster mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Turn the adjusting screw counter clockwise with a
-
screw-
driver until the push rod unlocked.
• Install the cam chain tension adjuster plug cap
3
.
The removed gasket must be replaced with a new one
to prevent oil leakage.
To Next Page
Loading...
